NOTE: An initial calibration is necessary when the new roll is a different label size. You do not need to calibrate after inserting a new roll of the same label size. Once the printer stops and the status indicator light is solid green, the calibration is complete.The printer will measure and feed a few blank labels. Hold the pause and cancel buttons down for 2 seconds and let go.Press the power button and wait for the solid green status indicator light.For the printer to recognize the size of your labels, perform an initial calibration: If your printer was plugged in and turned on before opening the Zebra Setup Utilities app, you will need to turn off and unplug your printer and close the Zebra Utilities app.
#Zebra printers manual#
#Zebra printers windows#
Click the windows icon in the lower-left and select Devices. After this is set, re-generate the labels and attempt print job.ġ. Ensure there is only one of the Zebra printers installed (current version is named Designer ZD410-203dpi ZPL).ģ. Click the windows icon in the lower-left and select ' Devices.'Ģ. Make sure there’s only one Zebra printer installedġ. Power it back on and plug it back into your computer. Power it off (unplug it from the power source / outlet)ģ. Is the 'QZ tray' icon red after its been reloaded? If so:Ģ. Then re-generate your labels in BLAZE and attempt the print job. In the lower-right-hand corner of your Windows desktop, open the icon tray, right-click on the green box and select ‘reload.’Ģ.
After this is set, re-generate the labels and attempt the print job(s).ġ. Set your width and height to the appropriate label size, keeping the rest of the configuration settings to their defaults.Ĥ. For Zebra Setup, open the Zebra Utility App by clicking the Windows button, then searching for ' Zebra Setup Utilities.' Once there, click Configure Printer Settings. There, you can set/confirm the label size matches the size labels you are printing out.Ģ. For BLAZE, after you've logged in, click Inventory -> Print Labels on the sidebar. Make sure label size is set correctly in BLAZE and Zebra Setupġ. The printer will automatically adjust or you can press the feed button twice before printing. NOTE: An initial calibration is necessary when the new roll is a different label size. You do not need to calibrate after inserting a new roll of the same label size.Once the printer stops and the status indicator light is solid green, the calibration is complete. The printer will measure and feed a few blank labels.ģ.
Hold the pause and cancel buttons down for 2 seconds and let go. Press the power button and wait for the solid green status indicator light.Ģ. Labels are printing incorrectly / Won't print more than one labelĮach of the following underlined steps can be attempted sequentially to correct the issue:ġ. To troubleshoot, click on the video here. If you find your Zebra Label Printer feeding out labels nonstop, then you will need to "Reset" the Label Sensor.
#Zebra printers Pc#
If you haven't actually set up your Zebra printer yet, follow the instructions here for PC and here for Mac. Having issues printing labels from your Zebra printer? Follow the steps below to troubleshoot and get your labels printing right.